3.5 Audio Generator Function
3-61
3
Measurement
DCS Polarity
■
Summary
Sets the polarity of DCS signal output.
This setting is enabled when Waveform is set to Tones+DCS.
■
Options
Normal Outputs DCS signals without inverting polarity.
Inverted Outputs DCS signal inverting polarity.
Output Noise
■
Summary
Sets Noise signal output to On/Off.
This setting is enabled when Waveform is set to Noise.
■
Options
On Sets Noise signal output to On.
Off Sets Noise signal output to Off.
Type
■
Summary
Sets the Noise signal type.
This setting is enabled when Waveform is set to Noise.
■
Options
1k Outputs 1k Tone signal.
1.25k Outputs 1.25k Tone signal.
Noise Outputs pseudo voice signal.
Level
■
Summary
Sets the Noise signal output level.
This setting is enabled when Waveform is set to Noise.
Note:
When Type is set to Noise, the level is set referencing the value in
the state that G.227 Filter is On. When G.227 Filter is Off, the
pseudo voice filter is bypassed (G.227) and the actual output level is
different from the level set for this parameter.
■
Setting range
When Output Type is Bal.:
0.001 to 12.400 Vrms
When Output Type is Unbal.:
0.001 to 6.200 Vrms
To Next Page
Loading...
