Anritsu MX269018A - Page 102

Chapter 3 Measurement
3-60
Tone3 Freq
■
Summary
Sets the frequency of Tone3.
This setting is enabled when Waveform is set to Tones.
■
Setting range
10.0 to 50000.0 Hz
Tone3 Level
■
Summary
Sets the Tone3 level.
This setting is enabled when Waveform is set to Tones.
■
Setting range
When Output Type is Bal.:
0.001 to 12.400 Vrms
When Output Type is Unbal.:
0.001 to 6.200 Vrms
DCS
■
Summary
Sets DCS signal output to On/Off.
This setting is enabled when Waveform is set to Tones+DCS.
■
Options
On Sets DCS signal output to On.
Off Sets DCS signal output to Off.
DCS Code
■
Summary
Sets the DCS code.
This setting is enabled when Waveform is set to Tones+DCS.
■
Setting range
0 to 777 (Set an octal number of 3 digits.)
DCS Level
■
Summary
Sets the DCS signal output level.
This setting is enabled when Waveform is set to Tones+DCS.
■
Setting range
When Output Type is Bal.:
0.001 to 7.000 Vp
When Output Type is Unbal.:
0.001 to 3.500 Vp