3.7 RX Measurement Mode
3-79
3
Measurement
Select AF1 Wave
■
Summary
Selects the Wave file stored in Folder of Drive selected with Device
setting. The selected file is used when AF1 Tone is set to User
Wave.
■
Destination to store Wave file
Create the following Folder in Drive to store Wave file.
[Drive]:\Anritsu Corporation\Signal Analyzer\User Data\Wave Data
■
Supported format for Wave file
Wave audio format is supported. The following restrictions apply:
Linear PCM file
(The compression format for ADPCM and expanded PCM cannot be
supported.)
Replay method is monaural or stereo.
(Multi-channel is not supported. For the stereo format, L-channel is
used for replay.)
The number of bits for sampling quantization is 8 bits or 16 bits.
(Modulation index is set for full scale on modulation.)
The data size allows replay time for 10 seconds or less.
The sampling frequency is any of 44.1 kHz, 48 kHz, or 96 kHz.
Note:
Even if the Wave file satisfies the specifications described above,
you may be unable to load the file. An error message is displayed
when specifying a Wave file that cannot be loaded.
Appendix A Error Message
To Next Page
Loading...
