Chapter 3 Measurement
3-78
LPF
■
Summary
Limits the range of DCS signal in AF level by using Low Pass Filter.
If set to On, removes high-frequency elements and controls noise at
demodulation.
■
Setting range
Off The range of DCS signal is not limited by Low
Pass Filter.
On The range of DCS signal is limited by Low Pass
Filter.
AF Monitor
■
Summary
Outputs the synthesized signals of AF1 Tone, AF2 Tone, and AF3
Tone (only when the MS2830A-018/118 is installed) to the monitor.
Outputs the signal to USB Audio. Enabled when USB Audio
equipment for signal output is connected to this instrument.
User waveform signal cannot be output.
■
Options
Off Stops the AF monitor.
On Starts the AF monitor.
Monitor Volume
■
Summary
Sets the AF monitor signal output level.
■
Setting range
0 to 100
Device
■
Summary
Sets Device to which User waveform is stored.
■
Setting range
Drive name (D, E, F,…)
To Next Page
Loading...
