Chapter 3 Measurement
3-102
3.10 Setting Terminals for External Device Control
This section describes the settings for external device control connectors.
The setting is enabled when the MS2830A-018/118 Audio Analyzer is
installed and it is common for TX measurement mode and RX
measurement mode.
Press F7 (Audio Func. Setting) in Page 2 of the main function menu to
display the Audio Func. Setting function menu.
Output1 – Output1
■
Summary
Sets Output1 to On/Off.
■
Options
On Sets Output1 to On.
Off Sets Output1 to Off.
Output1 - Polarity
■
Summary
Selects the Output1 logic.
■
Options
Pos. Sets Output1 to positive logic.
Neg. Sets Output1 to negative logic.
Output2 – Output2
■
Summary
Sets Output2 to On/Off.
■
Options
On Sets Output2 to On.
Off Sets Output2 to Off.
Output2 - Polarity
■
Summary
Selects the Output2 logic.
■
Options
Pos. Sets Output2 to positive logic.
Neg. Sets Output2 to negative logic.
To Next Page
Loading...
