Error Messages C-3 Self Test or Application Self Test Error Messages
MS20xxC UG PN: 10580-00305 Rev. L C-5
If any of the subtests shows FAILED, then check that the battery level is adequate for
operation or that temperature is within acceptable limits. Reset to factory defaults with
either Factory Defaults (Esc+On), or Master Reset (System+On).
Application Self Test Results Window — SPA
Caution
Use of Master Reset (System+On), will permanently erase all user saved setups
and measurement traces and will return the VNA Master to a full Factory Default
condition. Be sure to make backup copies of any important files before proceeding
with a Master Reset. If the error persists, contact your Anritsu Service Center.
Figure C-3. Application Self Test Results Window (Spectrum Analyzer mode)
To Next Page
Loading...
Need help?
General
