6-15 Preset Menu System Operations
6-14 PN: 10580-00305 Rev. L MS20xxC UG
6-15 Preset Menu
Key Sequence: Shift, Preset (1)
6-16 Power On Self Test
At power On, the VNA Master runs through a series of quick checks to ensure that the system
is functioning properly.
From the “System Menu”, the System Self Test (“Self Test” on page 6-4) runs a series of tests
that are related to the instrument itself. The Application Self Test (“Application Self Test”
on page 6-4) runs a series of tests that are related to the current operating mode of the
instrument.
If the VNA Master is within the specified operating range with a charged battery, and if the
self test fails, contact your Anritsu Service Center (anritsu.com/contact-us).
To start a self test when the system is already powered up:
1. Press the Shift key and then the System (8) key.
2. Press the Self Test submenu key. The Self Test results are displayed.
3. Press Esc to continue.
Preset: This key resets all parameter settings for the current measurement
mode to their factory default values, and switches the display to the default
view for that mode. Measurement settings specific to other modes, or
applications, are not affected.
Save: Press this key to open the Save dialog box (Figure 5-1) to name and
save the current operating settings, allowing them to be recalled later to
return the instrument to the state it was in at the time the setup was saved.
Note: Set the File type as Setup. Refer to “Save Menu” on page 5-9 for
details.
The saved setup can be named in the Save dialog. Use the Shift key to
toggle between uppercase and lowercase. Use the Left/Right directional
arrows to move the cursor position. Press Enter to save the setup.
Recall: Press this key to select and recall a previously stored instrument
setup using the “Recall Menu” on page 5-13. Use the Up/Down arrow keys
or the rotary knob to highlight the saved setup, and press Enter. All current
instrument settings are replaced by the stored setup information.
Figure 6-17. Preset Menu
To Next Page
Loading...
Need help?
General
