System Operations 6-12 Reset Menu
MS20xxC UG PN: 10580-00305 Rev. L 6-11
6-12 Reset Menu
Key Sequence: Shift, System (8)>System Options > Reset
Factory Defaults: Press this key to restore the instrument to the default
settings for all measurement modes and system settings, including
connectivity, language, and the display and audio settings. The instrument will
power cycle when the operation is complete. Press the Enter key to initiate
the reset, or press Esc to abort.
Note: This same reset sequence can be initiated when turning on the
instrument by pressing Power while holding down the Esc key until the
Anritsu splash screen is displayed.
Master Reset: Press this submenu key to restore the instrument to factory
defaults as described above and to delete all user files from the instrument
internal memory. The instrument will power cycle when the operation is
complete. Press Enter to initiate the reset, or press Esc to abort.
Note: This same reset sequence can be initiated when turning on the
instrument by pressing Power while holding down the System (8) key
until the Anritsu splash screen is displayed.
Update Firmware: This key is used for updating the instrument firmware.
Refer to “Firmware Update” on page 6-15 for detailed instructions.
Back: Press this key to return to the “System Options Menu” on page 6-8.
Figure 6-13. Reset Menu
Back
Master
Reset
Factory
Defaults
Update
Firmware
Reset
To Next Page
Loading...
Need help?
General
