Operating Guide 20
Antelope Camera Systems
3.3 Touchscreen CCU
The CCU touchscreen display (44) provides information about the actual status of the CCU
and its network connection. Beside the Mac address of the CCU you can find the port numbers of
the respective devices in the lower lines.
Pico CCU
Software Version v2.05
SERIAL: 00240022
SPL BR: 115 -- R:0
MAC:19:99:A0:54:49:49
DEV: PORT: CON.STATUS:
OCP 715 IP
RCP 725 SLAVE
ROP 735 D/C
NOTE: The port addresses of the other connected controllers must be set to the values
shown here in the display.
3.4 USB Firmware Update
Antelope Camera System provides firmware updates for its devices to help address any known
issues and to add new features.
Update the CCU firmware using a USB flash drive:
USB memory device requirements:
- USB specification 2.0 (or higher) and should not have more in capacity than 4GB.
- Should be Fat32 formatted and blank (should not contain any files)
1. Download the update file to your PC.
2. Rename file to "picoccu.bin".
3. Insert the USB storage device into your PC. Copy or drag and drop the firmware update file to
the root directory of your USB device.
Note! “The root directory” is the first or top-most directory of the device, which contains all
the other folders.
4. Make sure the CCU is powered off, then insert the USB flash drive into the USB Firmware
Update Port (45) on the CCU.
19
19
To Next Page
Loading...