Antelope Pico - Add Auto del; D;C Check; Reboot Camera

Operating Guide 70
Antelope Camera Systems
5.7.1.1 Add Auto Del.
The menu item Add Auto Del. allows to set a delay after the clip playback to delay automatically
erasing the actual clip in auto trigger recording mode. This is useful if you want to preserve to the
clip to show it again.
Values are 0-99 Seconds
Use the Pause Button (F) or Jog and Shuttle Dial (G/H) to hold the actual clip in pause mode and
prevent it from being erased.
5.7.1.2 D/C Check
Allows you to turn off the connection check between the controllers and the camera head.
Values are
On (default)
OFF
When this value is switched to off a green or red C in the top left corner of the RCP display
indicates if the camera headed is connected.
- A red C indicates the controller does not receive a feedback from the camera head, though the
camera might normally respond to all commands from the controller.
- A green C indicates the camera head is connected and the controller receives constant feedback.
Note! Turning on the feature might be useful in wireless environments, where no return
channel from the camera is available.
5.7.1.3 Reboot Camera
Reboots the camera. In rare cases rebooting might be necessary to recover from an error or to re-
initialize the camera.
Select YES or NO with Select dial (K). The arrow indicates the active item. By turning the Select
dial (K) you change the settings, then press the Select dial (K) once.
CONFIRM
REBOOT CAMERA:
NO =>YES
The process to reset the camera will take approximately 20 seconds.