Antelope Pico - In; out Point; Current Frame; Timeline; Pre-Trigger Indicator

Operating Guide 68
Antelope Camera Systems
If the Autoplay Mode Indicator (S) is displayed with a red background it indicates that Loop
Mode is switched on.
5.5.4 In / Out Point
The In / Current / Out Indicator (Q) displays the starting frame, the currently displayed frame and
the end frame of the actual video clip.
Mark 1: Current: Mark 2:
xx xx xx
Mark1:
Indicates the starting frame as set with the Mark Buttons (B+C).
Mark2:
Indicates the last frame of the sequence.
5.5.5 Current Frame
The middle of the In / Current / Out Indicator (Q) the current frame as dialed with the jog dial
on the timeline and shown on the replay channel is displayed.
5.5.6 Timeline
The timeline is a graphical representation of the actual video sequence. The red bars position
controls the display of the video preview. The actual position is shown over the red bar below
'Current' in frames.
5.5.7 Pre-Trigger Indicator
While being in Pre-Trigger mode , a red T above the timeline (R) in the RCP Display (N)
indicates the activated Pre-Trigger mode (Pre-Trigger Indicator (U)). The remaining recording time
(in Seconds) after pushing the Trigger Button (E) is indicated above the timeline (R)
behind the letters PTR. It counts down the remaining recording time until this clip is saved and
available for playback.
72
69
68
76 68 67
79 68