Operational Control Panel (OCP)
55
Antelope Camera Systems
4.22.6 TFLT Replay
TFLT is an enhanced denoise filter to reduce the very disturbing line flicker, that occurs in rare
cases.
TFLT REPLAY - reduces the line flicker in the replay
Values are ON / OFF
Note! It is recommended to keep this setting always off.
4.22.7 D/C Check
Allows you to turn off the connection check between the controllers and the camera head.
Values are
On (default)
OFF
When this value is switched to off a green or red C in the top left corner of the OCP display
indicates if the camera headed is connected.
- A red C indicates the controller does not receive a feedback from the camera head, though the
camera might normally respond to all commands from the controller.
- A green C indicates the camera head is connected and the controller receives constant feedback.
Note! Turning on the feature might be useful in wireless environments, where no return
channel from the camera is available.
4.22.8 Fixed Pattern
Fixed Pattern Noise (FPN) - activates fixed pattern noise (FPN) correction to further reduce
camera artifacts
Values are ON / OFF
Note! This setting should be always ON. Since each sensor receives its own individual noise
pattern file, which is stored in the CCU, it is not possible to mix different camera heads and
CCUs.
To Next Page
Loading...