Antelope Pico - Black Sun; Invert Image; Reboot Camera

Operational Control Panel (OCP)
37
Antelope Camera Systems
4.10.4 Black Sun
Under special circumstances (bright sun or floodlight) there is a camera artifact where overexposed
areas are displayed as black instead of white pixels, also referred to as "black sun” or "black hole"
phenomenon. By switching on this option, the chance of producing "black sun” artifacts is reduced.
Values are ON / OFF
Select the respective item by turning the Select dial (Q), then press the Select dial (Q) once. The
arrow indicates the active item. By turning the Select dial (Q) you change the settings. Confirm your
settings by pressing the Select dial (Q) once.
Note! The Black Sun feature cannot be used in a general dark environment or with an
increased gain value. In case you might experience white stripe artifacts in the picture, it is
recommend to turn this feature off.
4.10.5 Invert Image
This function allows to mirror the image horizontally and vertically. Select the respective item by
turning the Select dial (Q), then press the Select dial (Q) once. The arrow indicates the active
item. By turning the Select dial (Q) you change the settings.
Values are ON / OFF
Select On or OFF with Select dial (Q).
4.10.6 Reboot Camera
Reboots the camera. In rare cases rebooting might be necessary to recover from an error or to re-
initialize the camera.
Select YES or NO with Select dial (Q). The arrow indicates the active item. By turning the Select
dial (Q) you change the settings, then press the Select dial (Q) once.
CONFIRM
REBOOT CAMERA:
NO =>YES
The process to reset the camera will take approximately 20 seconds.