Operational Control Panel (OCP)
33
Antelope Camera Systems
4.10.1.2 Video Level
Sets the white point (white clip level) beyond 100% in units of 1%. Select the respective item by
turning the Select dial (Q), then press the Select dial (Q) once. The arrow indicates the active
item. By turning the Select dial (Q) you change the settings. Confirm your settings by pressing the
Select dial (Q) once.
Values are 100-107%
4.10.2 Genlock
The Genlock feature allows the camera to synchronize to a reference signal provided at the
Genlock Input (22) at CCU .
4.10.2.1 Genlock
Values are ON / OFF
Select On or OFF with Select dial (Q) to lock the camera to a reference sync signal. The arrow
indicates the active item. By turning the Select dial (Q) you change the settings, then press the
Select dial (Q) once. Before switching on this feature make sure the cable providing the Genlock
signal is connected to the CCU or camera. (Depending on camera type). After switching this feature
on, the camera automatically searches the genlock signal for 15 seconds. In case no valid signal
can be detected the Genlock function is automatically switched off.
4.10.2.2 Resync
Use this function to start the Genlock syncing procedure again. Select the respective item by turning
the Select dial (Q), then press the Select dial (Q) once.
Values are ON / OFF
Select On or OFF with Select dial (Q).
4.10.2.3 Input
Set Genlock reference input standard. Select the respective item by turning the Select dial (Q),
then press the Select dial (Q) once. The arrow indicates the active item. By turning the Select dial
(Q) you change the settings. Confirm your settings by pressing the Select dial (Q) once.
Values are
Tri-Level - Tri-Level Sync
Crosslock - Crosslock Sync - Make sure you set the right crosslog video format in the Crosslog
Signal menu
Pal BB - Black Burst PAL Standard
NTSC BB - Black Burst NTSC Standard
18 18
34
To Next Page
Loading...