Operating Guide 54
Antelope Camera Systems
4.22.3 Matrix
In the Matrix menu the color correction matrix settings can be adjusted.These are advanced settings
to control the palette of colors generated by the camera. The 3x3 color matrix describes the
balancing of different parts of the color spectrum in order to achieve optimum color reproduction for
capture. It describes not only the three primary colors, but their relationships to one another. Adjust
the color matrix settings with the Color Matrix Dials (G) and (I) for color adjustment of the blacks.
Press Select for defaults
Reset your matrix settings to default values by pressing the Select dial (Q) once.
4.22.4 RAW
SDI range - Switches between legal and extended signal mapping. A 10-bit digital signal can
theoretically carry code values from 0 to 1023. A legal range signal only uses code values 64 to 940
(for the Y channel) while an extended range signal uses code values 4 to 1019 (for the Y channel).
Values are 0/1
0 = Legal SDI Range
1 = Extended SDI Range
RAW - Switches the uncompressed RAW data output over HD-SDI on. Because the RAW HD-SDI
output is not a standardized HD-SDI format, special recording equipment is required to correctly
interpret and display the RAW data.
Values are 0/1
0 = RAW data output over HD-SDI OFF
1 = RAW data output over HD-SDI ON
4.22.5 TFLT Live
TFLT is an enhanced denoise filter to reduce the very disturbing line flicker, that occurs in rare
cases.
TFLT LIVE - reduces the line flicker in the live output
Values are ON / OFF
Note! It is recommended to keep this setting always off.
To Next Page
Loading...