Remote Control Panel (RCP)
73
Antelope Camera Systems
5.7.5.1 Autoplay Starting Frame Setup
In the A. PL. Frame (Autoplay Frame) menu is defined how much earlier the autoplay playback
starts in relation to the end point set with the Trigger Button (E). This is achieved by specifying a
number of frames for the replay to start before the end point. For example setting this value to 75
causes the replay to start 75 frames before the end of the replay.
Values are 0-9999
Please note! This Menu item is only available if Autoplay Setup is switched on otherwise it is
grayed out!
5.7.5.2 Autoplay Button Setup
In the A. PL. PST. (Autoplay Presets Setup) menu is defined how much earlier the autoplay
playback in Full Auto Mode starts in relation to the end point set with the Trigger Button (E).
This is achieved by assigning different buttons a number frames for the replay to start before the
end point. Select the respective Key by turning the Select dial (K), then press the Select dial (K)
once. The arrow indicates the active item. By turning the Select dial (K) you change the settings.
Confirm your settings by pressing the Select dial (K) once.
Key1: <= 0100
Key2: 0150
Key3: 0200
Key4: 1000
For example setting this value to 75 causes the replay to start 75 frames before the end of the
replay.
Values are 0-9999
The Key 1-4 are assigned to these buttons on the RCP:
Key 1 – Mark 1 Button (B)
Key 2 – Mark 1 Button (C)
Key 3 – Goto 1 Button (I)
Key 4 – Goto 2 Button (J)
Please note! This Menu item is only available in Full Auto Mode and otherwise it is grayed
out!
72
67
66
66
66
66
72
To Next Page
Loading...