Operating Guide 44
Antelope Camera Systems
4.15 Detail / Denoise menu
Push the Detail / Denoise Button (E) to switch to the detail / denoise settings menu.
In the detail / denoise settings menu the image detail and denoise parameters are defined. Select
the respective item by turning the Select dial (Q), then press the Select dial (Q) once. The arrow
indicates the active item. By turning the Select dial (Q) you change the settings. Confirm your
settings by pressing the Select dial (Q) once. If the detail or denoise function is enabled the Detail /
Denoise Button (E) will be lit.
Enable
Values are ON/OFF
Detail LVL
The image detail menu allows you to adjust the detail level of the image.
Values range from 0-63
Denoise LVL
The denoise function removes distracting visible image noise. Use the denoise menu to adjusts the
denoise level of the image.
Values range from 0-63
4.16 Deflicker menu
The deflicker engine is an optional feature and only available if your camera is equipped
with a deflicker board or you are using the Colibri deflicker ! Deflickering of 50/60 P is only
available with Colibri Deflicker Deflicker V2.
Any slow motion cameras show flickering artifacts in the slow motion playback just because of the
interference between the flickering of the light sources and the frame rate of the camera. This
physical effect cannot be avoided when using regular lighting (not flicker free), like in most football
stadiums for example. The integrated deflicker engine uses a complex signal processing algorithm
to output a “clean” HD-SDI signal without these artifacts.
Push the Deflicker Button (D) to switch to the Deflicker menu.
In the Deflicker menu all parameters of the deflicker engine can be set. Select the respective item
by turning the Select dial (Q), then press the Select dial (Q) once. The arrow indicates the active
item. By turning the Select dial (Q) you change the settings. Confirm your settings by pressing the
Select dial (Q) once.
Deflicker Menu Settings
Strength - sets the degree of the deflicker effect
Values range from 0-12
The higher this value is set, the less flicker is visible and the cleaner the processed image looks.
To Next Page
Loading...