Operational Control Panel (OCP)
45
Antelope Camera Systems
Please note, that using high deflicker strength values also cause stronger motion blur
effects in the processed image.The recommended starting value is 9.
Status - switch the deflicker function on or off.
Values are
off - Deflicker switched off
Replay only - in replay only mode the deflicker function is only active on slow-motion replays.
(Recommended setting)
Note! Turn the deflicker engine off for camera recording speeds of 50 FPS or less.
Freq. Shift - Allows to fine tune the deflicker signal processing results. Values range from -233 -
+517 (Recommended value is 0)
Different conditions and scenes require different settings. Please test the best settings for your
shots. If you have a scene with special lights and there are only poor results, please do not hesitate
to contact us and send us a sample clip and we will improve our algorithm.
Note! When working daylight conditions with no artificial light the deflicker engine must be
disabled!
To Next Page
Loading...