Antelope Pico - IP Setup

Operating Guide 50
Antelope Camera Systems
4.21 IP Setup
The IP properties (IP, Subnetmask and Gateway) of the OCP can be changed.
To enter the IP setup menu on the OCP press and hold the Gain/Hue Button (B) and the
Bl.Stretch/Flare (L) button simultaneously, while powering (booting) up the OCP. Select Config
Mode... by turning the Select dial (Q), then press the Select dial (Q) once. This load loads the
current settings.
IP SETUP
CONFIG MODE...
LOCAL IP ADDRESS:
192 168 001 155
SUBNET:
255 255 255 000
GATEWAY
192 168 001 001
LOCAL PORT 23
CAM IP ADDRESS:
192 168 001 050
SERVER PORT:23
SEND: IP SN GW SIP REBOOT
By turning the Select dial (Q) you can choose the value to be changed. The arrow indicates the
active item. Press the Select dial (Q) once and change the value by turning the Select dial (Q). To
save the settings select and press SEND on the bottom left. A successful saving of the new settings
is indicated by a SUCCESS message behind CONFIG MODE on the top if the display.
It is necessary to reboot the OCP in order for new settings to take effect. This can be done by
selecting and pressing REBOOT on the bottom right of the menu.
Note! The port address is factory set to 715 and should always match the values indicated in
the CCU touchscreen display (44).
25
25