Operational Control Panel (OCP)
53
Antelope Camera Systems
Relative
4.22.2 Expert Deflicker Menu
Status - switch the deflicker function on or off.
Values are
off - Deflicker switched off
replay only - in auto mode the Deflicker is only active on slow-motion replays. (Recommended
setting)
Frequency - Allows to set frequency of your light source in relation to the used the power line
frequency in Herz. Values range from 50-100
V-Boost - Switch the V-Boost function on or off. This optimizes the deflicker results for vertical
camera pans and for objects moving vertically through picture. Values are on/off.
Module - Select if your use an integrated deflicker board or the standalone Colibri deflicker
Values are Integrated / Standalone (Colibri deflicker connected via RS485)
Reboot - Select to reboot the deflicker electronics.
Video Mode
Note! In order to operate correctly the HD format setting of the deflicker module has to be
set to the same value as the camera.
The video HD format for the Deflicker is automatically set by the camera and should be only
changed, if it is really necessary. Select the respective item by turning the Select dial (Q), then
press the Select dial (Q) once. The arrow indicates the active item. By turning the Select dial (Q)
you change the settings. Confirm your settings by pressing the Select dial (Q) once.
Format
Values are
1080i 50
1080i 60
1080i/59.94
1080p 23.98
1080p 24
1080p 25
1080p 29.97
1080p 30
1080p 50
1080p 60
720p 50
720p 59.94
720p 60
Freq. Shift - Allows to fine tune the deflicker signal processing results. Values range from -233 -
+517 (Recommended value is 0)
To Next Page
Loading...