Operating Guide 58
Antelope Camera Systems
4.22.11 Mem Test
When startung and booting the camera an EEPROM test is performed automatically. To start this
function manually select MEM TEST with the Select dial (Q). The arrow indicates the active item
Then press the Select dial (Q) once to start the EEPROM test.
The camera returns
MEM TEST <= SUCCESS
or
MEM TEST <= FAIL
The display should show SUCCESS. FAIL indicates a defective EEPROM module.
Note! In case this test indicates FAIL, get in touch with Antelope Camera System GmbH
have your unit serviced.
98
To Next Page
Loading...