Operating Guide 56
Antelope Camera Systems
4.22.9 Cam Eng Reset
The Camera Engineer Reset function has to be used very carefully. It deep resets the camera by
clearing memory completely. The process to reset the camera will take 10 seconds.
Select YES or NO with Select dial (Q). The arrow indicates the active item. By turning the Select
dial (Q) you change the settings, then press the Select dial (Q) once.
CONFIRM
FACTORY RESET:
NO =>YES
The process to reset the camera will take approximately 10 seconds.
The OCP displays
DEEP RESET COMPLETE
and returns to the menu again after the reset is finished.
Note! After performing a deep reset, make sure you switch the Fixed Pattern on again.
Also check the Playmode and Multimatrix settings!
55
71 34
To Next Page
Loading...