Operating Guide 72
Antelope Camera Systems
5.7.3 Workflow Setup
The menu item WORKFLOW allows to set the preferred trigger mode. There are three triggering
modes available:
Values are
STANDARD - In standard trigger mode activated banks are recorded to by pushing the Trigger
Button (E). After triggering the filled banks have to be cleared in order to
be used again. To clear the memory banks simultaneously push the Clear
Bank/Lock Bank button (M) and the corresponding Bank Number Button (A).
LOOP - In Loop trigger mode activated banks are recorded to by pressing the Trigger
Button (E). Pressing the Trigger Button (E) again overwrites the next available
bank. Banks can be locked by simultaneously pushing the Clear Bank/Lock Bank
button (M) and the corresponding Bank Number Button (A).
FULL AUTO - In this advanced mode, after pushing the Trigger Button (E) the playout starts
automatically at a predefined number of frames back. (see also A.Pl.
and PST) After the playback is finished the according bank is automatically erased,
the buffer recording starts again and the memory bank is ready to be triggered
again. This feature can only be used with one memory bank.
Note! Banks which are in use and therefor have the status Play cannot be deleted!
5.7.4 Setting Active Memory Banks
The menu item BANK NUMBER allows to set the number of active memory banks.
Values range from 1-4
Pleas note! The total available capture time is split equal between the number of your banks, f.e.
available capture time at 280FPS is 10.65s real time, if 2 banks are selected both banks have an
available capture time of 5.32s real time, 3 banks 3.55s, 4 banks 2.66s.
5.7.5 Autoplay Setup
The menu item Autoplay allows to switch the automatic playback mode on. With autoplay switched
ON the replay starts immediately after triggering.
Values are On / Off
Select On or OfFf with Select dial (K). The arrow indicates the active item. By turning the Select
dial (K) you change the settings, then press the Select dial (K) once.
To Next Page
Loading...