Antelope Pico - Bit Depth; Framerate; Camera Speed; Fps; Play Mode

To Next Page

To Previous Page

Remote Control Panel (RCP)

Antelope Camera Systems

5.7.1.4 Bit Depth

The bit depth relates to how many different brightness levels are available in each of the three red,

green and blue color channels. This menu item indicates the current bit depth, depending on the

selected frame rate. For frame rates higher than 283 frames per second, only 8 bit depth can be

used.

024 - 283 fps = 10 bit depth

284 - 350 fps = 8 bit depth

5.7.2 Framerate / Camera Speed

5.7.2.1 FPS

In the fps menu the camera recording frame rate (in frames per second) is defined. Select the

respective item by turning the Select dial (K), then press the Select dial (K) once. The arrow

indicates the active item. By turning the Select dial (K) you change the settings. Confirm your

settings by pressing the Select dial (K) once.

FPS

In the FPS menu the selection of the frames per second is defined.

1-350 fps in 8 bit mode

1-283 fps in 10 bit mode

Please note that it is necessary to use the OCP to set the camera to 8 bit mode in order

to set higher frame rates than 283 fps.

5.7.2.2 Play Mode

In the Play Mode menu the Video Out signal is set. Select the respective item by turning the Select

dial (K), then press the Select dial (K) once. The arrow indicates the active item. By turning the

Select dial (K) you change the settings. Confirm your settings by pressing the Select dial (K)

once.

Play Mode

Values are

Interlaced (50i)

Full Frame (25psf)

Full Frame EXT (extended) - plays out video sequence in half speed