CCU (Camera Control Unit)
21
Antelope Camera Systems
5. Now power on the CCU using the On/Off Switch (46) .
WARNING: During the software installation process, please do not remove the USB device
or turn off the CCU!
6. When the software update is complete, the CCU display (44) indicates the new software
version:
Pico CCU
Software Version v2.05
SERIAL: 00240022
SPL BR: 115 -- R:0
MAC:19:99:A0:54:49:49
DEV: PORT: CON.STATUS:
OCP 715 IP
RCP 725 SLAVE
ROP 735 D/C
7. Remove the USB flash drive.
NOTE: If you have any difficulty carrying out these instructions, please contact Antelope
Camera System.
3.5 Baudrate Setup
It is possible to change the data rate in bits per second (baud) for serial data transmission between
the control units.
To setup the baud rate for the CCU
1. Remove the 2 screws on each side of the CCU case.
2. Open the CCU case by removing the top cover.
3. Now press blue button on the corner of the white electronics board to open the expert mode
menu on the CCU touchscreen (44) . Options are 9.6K 56K and 115K.
4. Now choose the new baud rate on the CCU touchscreen.
5. Put the lid back on the housing and put the 4 screws back accordingly.
Expert MODE
SPL BR: 9.6K 56K 115K
Motor: IRIS FOC. ZOOM
STATUS:
BACK
19
19
19
To Next Page
Loading...