Antelope Pico - Sleep Mode; Shuttle Pause Setup; Shuttle Play Setup

Operating Guide 74
Antelope Camera Systems
5.7.6 Sleep Mode
The sleep or standby mode is reducing the wear on the camera head and saves power. By
activating this mode the camera head is put to standby mode and the sensor and image processing
electronics are completely switched off. Antelope Camera Systems recommends to use this option,
when the mounted cameras will not be in use for more than one hour.
Select YES or NO with Select dial (K). The arrow indicates the active item. By turning the Select
dial (K) you change the settings, then press the Select dial (K) once.
CONFIRM
SLEEP MODE
NO =>YES
When the sleep mode is active the camera does not provide a HDSDI signal and the display shows:
SLEEP MODE
ACTIVE
PRESS MENU TO EXIT
Press the Menu Dial (DS) once to stop the sleep mode.
5.7.7 Shuttle Pause Setup
The Shuttle Pause setup menu item sets the sensitivity of the outer jog dial (h) in pause mode.
Increase the value for faster jog shuttle scrolling.
Select the respective item by turning the Select dial (K), then press the Select dial (K) once. The
arrow indicates the active item. By turning the Select dial (K) you change the settings. Confirm your
settings by pressing the Select dial (K) once.
Values are 1-99
5.7.8 Shuttle Play Setup
The Shuttle Pause setup menu item sets the sensitivity of the outer jog dial (h) in play mode.
Increase the value for faster jog shuttle scrolling.
Select the respective item by turning the Select dial (K), then press the Select dial (K) once. The
arrow indicates the active item. By turning the Select dial (K) you change the settings. Confirm your
settings by pressing the Select dial (K) once.
Values are 1-99
69
69