Remote Control Panel (RCP)
77
Antelope Camera Systems
PTR 75
In this mode, when pushing the Trigger Button (E) 25% of the previous buffered video sequence
(duration depends on the available capture time) in the actual memory bank are stored and an
additional 75% will be recorded before this clip is then saved and available for playback.
PTR 100
This sets the camera to start trigger mode.The camera will start acquiring a high-framerate clip
(duration depends on the available capture time) as soon as the trigger button is hit and will then
save the sequence, as soon as the memory buffer is fully used.
Note! While recording a high-framerate sequence in Pre-Trigger mode you can shift the trigger
point to a later trigger point by pushing the Trigger Button (E). With each push of the Trigger
Button (E) the the trigger point is newly set.
To Next Page
Loading...