Astraada SRV-64 - Page 162

AS64 series AC servo drive Function codes
-156-
Modbus address
1872, 1873
CANopen address
0x2424, 0x00
P4.37
Main-power UV
detection time
Setting range
Default
Unit
Applicable
mode
70–2000
70
ms
P
S
T
This parameter specifies the time taken to detect main power undervoltage.
Note: The value 0 indicates the function of detecting main power undervoltage is invalid.
P4.37
Data size
16bit
Data format
DEC
Modbus address
1874, 1875
CANopen address
0x2425, 0x00
P4.38
Motor overload rate
Setting range
Default
Unit
Applicable
mode
0.0–500.0
115.0
%
P
S
T
The parameter specifies the overload rate of the motor.
The default value is 115.0%. When the value of the parameter is enlarged, please take the motor
overload capacity into consideration.
P4.38
Data size
16bit
Data format
DEC
Modbus address
1876, 1877
CANopen address
0x2426, 0x00
P4.39
Speed deviation
threshold
Setting range
Default
Unit
Applicable
mode
0–20000
0
r/min
P
S
This parameter specifies the condition for detecting the speed deviation fault. If the absolute value
of the actual speed command minus the motor speed is greater than the setting of this parameter
and the deviation lasts more than 100ms, a speed deviation alarm is reported.
Note: The value 0 indicates no detection on speed deviation faults.
P4.39
Data size
16bit
Data format
DEC
Modbus address
1878, 1879
CANopen address
0x2427, 0x00
P4.40
Forward speed limit
Setting range
Default
Unit
Applicable
mode
0–20000
20000
r/min
P
S
T
This parameter specifies the maximum limit on the forward speed command.
Note: The default value and setting range of this parameter are associated with the drive power
class.
P4.40
Data size
16bit
Data format
DEC
Modbus address
1880, 1881
CANopen address
0x2428, 0x00
P4.41
Reverse speed limit
Setting range
Default
Unit
Applicable
mode