Atrust T180L - Creating the Mapping of IP Addresses to Names of Hosts

Conguring Client Settings
Conguring Network Settings
101
4.5.7 Creating the Mapping of IP Addresses to Names of Hosts
Atrust Client Setup allows you to use the name or alias of a host instead of its IP address wherever you need to
specify an IP address while conguring client settings. To use this feature, rst you need to create the mapping of IP
addresses to names or aliases of hosts.
Creating the Mapping List
To create the mapping of IP addresses to names or aliases, please do the following:
1. On Atrust Client Setup, click Network > Hosts to open the Host list.
2. Click Add to start adding a new host entry.
3. Type in the name, IP address, alias of a host, leave the Priority eld blank, and then click Save to apply.
NOTE
• If your host belongs to a domain, please don’t enter the FQDN (Fully Qualied
Domain Name) or full computer name in the Hostname eld. Enter only the
computer name of the host in this required eld.
• You need to type a number in the Priority eld only when creating a Failover Cluster
list to allow host failover feature. For details, please refer to “4.5.8 Conguring the
Failover Cluster List” on page 103.