Atrust T180L - Configuring the Quick Connection Mode; Enabling or Disabling Auto Setup

Conguring Client Settings
Conguring System Settings
54
4.2.8 Enabling or Disabling Auto Setup
Auto Setup allows your thin client to get its preset conguration on startup and enter the desired user environment
automatically. Its operation requires Auto Setup environment and network connectivity, except for Auto Setup on
the client side. For details, please refer to User’s Guide for Auto Setup.
NOTE
• To disable Auto Setup after your thin client got its preset conguration, reset your
client. Please refer to “A.1 Resetting Your t180L/t180LB to the Factory Default” on
page 213.
4.2.9 Conguring the Quick Connection Mode
The Quick Connection mode enables you to enter the Atrust Quick Connection screen after system startup.
This setting is enabled by default.
NOTE
• For detailed instructions on how to use your t180L/t180LB under the Quick
Connection mode, please refer to section “3.1 Learning the Basics” on page 19.
• There are three similar but dierent modes for your t180L/t180LB and only one
mode will take eect if all are enabled. Three modes and the order of priority are
listed as follows:
No. Mode Description
1 Appliance
The client will start up directly with the desired
RDP / ICA / View session and perform the
congured action after exiting the session.
Available actions include:
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
2 Autostart
The client will start up directly with the desired
RDP / ICA / View session and perform the
congured action after exiting the session.
Available actions include:
• Returning to the local desktop
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
3 Quick Connection
The default. The client will enter Atrust Quick
Connection screen after system startup.