Atrust T180L - Enabling or Disabling the Appliance Mode

Conguring Client Settings
Conguring System Settings
50
4.2.7 Enabling or Disabling the Appliance Mode
The Appliance mode allows your t180L/t180LB to start up directly with the desired Microsoft Remote Desktop,
Citrix ICA, VMware View or Horizon View session. Under this mode, users will feel as if they were using a standalone
desktop computer; the underlying client operating system, Atrust Linux, is hidden from the very beginning.
NOTE
• There are three similar but dierent modes for your t180L/t180LB and only one
mode will take eect if all are enabled. Three modes and the order of priority are
listed as follows:
No. Mode Description
1 Appliance
The client will start up directly with the desired
RDP / ICA / View session and perform the
congured action after exiting the session.
Available actions include:
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
2 Autostart
The client will start up directly with the desired
RDP / ICA / View session and perform the
congured action after exiting the session.
Available actions include:
• Returning to the local desktop
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
3 Quick Connection
The default. The client will enter Atrust Quick
Connection screen after system startup.
• For more information on these modes, please refer to sections:
 4.2.9 on page 54 and 3.1 on page 19 (Quick Connection mode)
 4.2.7 on page 50 (Appliance mode)
 4.6.5 on page 131 (Autostart mode for RDP sessions)
 4.6.11 on page 169 (Autostart mode for ICA sessions)
 4.6.14 on page 202 (Autostart mode for View sessions)