Atrust T180L - Page 63

Conguring Client Settings
Conguring System Settings
53
6. The system will enter the Appliance mode after restart.
NOTE
• To disable the Appliance mode or to access Atrust Client Setup under the Appliance
mode, please refer to “Disabling the Appliance Mode” on page 53.
Disabling the Appliance Mode
To disable the Appliance mode, please do the following:
1. Under the Appliance mode, exit the Full Screen mode of the RDP / ICA session, or release the keyboard and
mouse from the View session (virtual desktop):
• To exit the Full Screen mode of the RDP session, press Ctrl + Alt + Enter, and then minimize
the session window.
• To exit the Full Screen mode of the ICA session, press Ctrl + F2, and then Alt + F9.
• To release the keyboard and mouse from the View session (virtual desktop), press Ctrl + Alt.
NOTE
• Please note that the View session (virtual desktop) will remain on the background
after you release the keyboard and mouse from the View session (virtual desktop).
2. Click Ctrl + Shift + Del to launch Atrust Client Setup.
NOTE
• You cannot access the Taskbar of the client operating system (Atrust Linux) under
the Appliance mode.
3. On Atrust Client Setup, click System > Appliance Mode.
4. Click to uncheck Enable Appliance Mode, and then click Save to apply the change.
5. Return to the current RDP / ICA / View session:
• To return to the current RDP / ICA session, use Alt + Tab (press and hold Alt, and then press Tab to switch
between dierent items) to select and restore the current RDP / ICA session.
• To return to the current View session, click any place of the View session (virtual desktop)
on the background.
6. Log o from the current RDP / ICA / View session.
7. The client will shut down then. Restart your client manually.