Atrust T180L - Page 214

Conguring Client Settings
Conguring Service Access Settings
204
Autostart When Startup
Select whether to open a VMware View or Horizon View session automatically or
not when your t180L/t180LB is started up (Autostart mode).
NOTE: There are three similar but different modes for your t180L/t180LB and
only one mode will take effect if all are enabled. Three modes and the
order of priority are listed as follows:
No. Mode Description
1 Appliance
The client will start up directly with the desired
VMware View or Horizon View session and perform
the congured action after exiting the session.
Available actions include:
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
2 Autostart
The client will start up directly with the desired
VMware View or Horizon View session and perform
the congured action after exiting the session.
Available actions include:
• Returning to the local desktop
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
3 Quick Connection
The default. The client will enter Atrust Quick
Connection screen after system startup.
NOTE: To use the Autostart mode, ensure that the Appliance mode is disabled.
On Application Exit
Select what to do when a VMware View or Horizon View session is ended.
Four options are available: Do Nothing, Restart Application, Reboot,
and Shutdown.
Option Description
Do Nothing Returns to the local desktop.
Restart Application Opens a VMware View or Horizon View session again.
Reboot Restarts your thin client.
Shutdown Turns off your thin client.