Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Plenum Chamber Cover with Screws
– Remove the bolts -3- and -4-.
– Remove rubber seal -1-.
– Pull plenum chamber cover -2- vertically up from the window
edge starting carefully with the windshield catches -arrows-.
1.5 Engine Mount Brace Reinforcement
1 - Engine mount brace
❑ If brace must be re‐
moved from bracket, re‐
move bolts -2-.
WARNING
When installing, rein‐
forcement -3- must be
slid into brace -1-.
2 - Bolt
❑ 23 Nm
❑ When tightening to tor‐
que, counterhold at nut
-5- with open end
wrench.
3 - Brace reinforcement
4 - Bracket
5 - Nut
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
6 Rep. Gr.50 - Body Front
To Next Page
Loading...
