Audi TT 207 - 1.4.1 Rear Bumper Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.2 Front Bumper - Audi TT RS
⇒ “1.2.1 Front Bumper Assembly Overview“, page 156
⇒ “1.2.2 Impact Member and Impact Absorber Assembly Over‐
view“, page 158
1.2.1 Front Bumper Assembly Overview
1 - Bolt
❑ Quantity: 4
❑ 2 Nm
2 - Upper part of spoiler
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.5 Spoiler Upper
Part“, page 173
3 - Right air intake grille
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.3 Air Intake
Grille“, page 172
4 - Right spray nozzle cover
❑ for the headlamp wash‐
er system
❑ Removing and Instal‐
ling, refer to ⇒ Electrical
Equipment; Rep. Gr.
92 ; Removal and Instal‐
lation
5 - Bolt
❑ Quantity: 4
❑ 2 Nm
6 - Guide piece
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.2 Front Bumper
Guide Piece“,
page 172
7 - Nut
❑ Quantity: 4
❑ 4 Nm
8 - Inner cover
❑ Removing and Installing, refer to ⇒ “2.2.4 Inner Cover“, page 173
9 - Bolt
❑ Quantity: 2
❑ Tightening Specifications and Sequence ⇒ page 157
10 - Bumper
❑ Removing and Installing, refer to ⇒ “2.2.1 Front Bumper“, page 170
11 - Left air intake grille
❑ Removing and Installing, refer to ⇒ “2.2.3 Air Intake Grille“, page 172
12 - Lower part of spoiler
❑ Removing and Installing, refer to ⇒ “2.2.6 Spoiler Lower Part“, page 173
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
156 Rep. Gr.63 - Bumpers