Audi TT 207 - Hood Gap Dimensions

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
12 - Gas strut
❑ Removing and Installing, refer to ⇒ “2.2.6 Gas-Filled Strut“, page 40
13 - Ball head pin
❑ 23 Nm
14 - Nut
❑ 34 Nm
1.2.2 Hood Gap Dimensions
Hood Gap Dimensions with Respect To Radiator Grille, Bumper,
Headlamp
A - Hood to bumper
• Gap dimension-a- = 4.5 +/-
0.5 mm
-1- hood
-2- bumper
❑ Adjusting, refer to
⇒ “1.2.3 Hood, Adjust‐
ing“, page 14
B - Hood to radiator grille side
• Gap dimension -b- from top
to bottom = 4.0 to 2.5 +/- 0.5
mm
-1- hood
-3- Radiator grille
❑ Adjusting, refer to
⇒ “1.2.3 Hood, Adjust‐
ing“, page 14
C - Hood to radiator grille
• Gap dimension -c- = 4.4 +/-
0.5 mm
• Projection -d- = 1.5 +/- 0.5
mm
-1- hood
-3- Radiator grille
❑ Adjusting, refer to
⇒ “1.2.3 Hood, Adjust‐
ing“, page 14
D - Hood to headlamp
• Gap dimension -e- from top to bottom = 3.0 to 1.6 +/- 0.5 mm
• Projection -f- = 3.0 +/- 0.5 mm
Gap Dimensions of Hood to Fender, Front Door
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Description and Operation 13