Audi TT 207 - Hood Release Lever

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.1.11 Hood Release Lever
Removing
1 - Screws
❑ 12 Nm
2 - Hood release lever mount‐
ing bracket
❑ No replacement part
3 - Cable
❑ If installed correctly, ca‐
ble must be guided in id‐
ler pulley -arrow- in
mounting bracket -2-.
4 - Hood release lever
❑ Release lever cover re‐
moved
❑ Lower »A-pillar« trim re‐
moved
❑ Remove screws -1- and
disengage release ca‐
ble -3-.
5 - Internally threaded pop rivet
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
36 Rep. Gr.55 - Hood, Lids