Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the electrical harness connector from the bracket by
releasing the retaining bracket -5-.
– Disconnect the connector -4-.
– Cut through cable tie -1-.
– Thread the wiring harness out of the lock carrier.
– Unlock retaining bracket -3- and detach and remove the hood
contact switch -F266- in the -direction of the arrow- from lid
lock -2-.
Installation
• For the correct tightening specifications, refer to
⇒ “1.2.4 Hood Locks Assembly Overview“, page 16 .
Install in reverse order of removal. Note the following:
– Install the bumper ⇒ “2.2.1 Front Bumper“, page 170 .
2.3.2 Fuel Filler Door Unlock Motor V155
Note
♦
Central locking functions electronically.
♦
Actuators in doors are integrated in the door lock and have 2
motors.
♦
Actuators cannot be replaced separately.
♦
The first motor locks the door and the second motor locks the
interior door mechanism (Safe function).
♦
Now, doors also can no longer be opened from the interior.
♦
After an accident in which the airbag deploys, the central lock‐
ing system control module opens any doors which were
locked.
♦
The central locking control module is located inside the right
rear side panel.
Special tools and workshop equipment required
♦ Socket wrench -T10010- .
Assembly Overview
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation 99
To Next Page
Loading...
