Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.4.7 Rear Bumper Bracket
Removing
– Remove bumper. Refer to ⇒ “2.4.1 Rear Bumper“, page 182 .
– Remove the nut -2-.
– Remove bumper bracket -1- from the body.
Installation
• For the correct tightening specifications, refer to
⇒ “1.4.2 Impact Member, Shock Absorber and Guide Piece
Assembly Overview“, page 161 .
Install in reverse order of removal. Note the following:
Note
The threaded pin -arrow- is only used for fastening the bracket.
– Install the bumper. Refer to
⇒ “2.4.1 Rear Bumper“, page 182 .
2.4.8 Guide Piece
Removing
– Remove bumper. Refer to ⇒ “2.4.1 Rear Bumper“, page 182 .
– Remove the screws -arrows- and nuts -2-.
– Remove guide piece -1-.
Installation
• For the correct tightening specifications, refer to ⇒ page 162 .
Install in reverse order of removal. Note the following:
– Tighten the screws and nuts in the following sequence:
-1 through 4-.
– Install the bumper. Refer to
⇒ “2.4.1 Rear Bumper“, page 182 .
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation 187
To Next Page
Loading...
