Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.4.9 Inner Guide Piece
Removing
– Remove bumper. Refer to ⇒ “2.4.1 Rear Bumper“, page 182 .
– Remove Radio frequency controlled clock receiver -J489- -1-
if applicable. Refer to ⇒ Electrical Equipment; Rep. Gr. 90 ;
Removal and Installation .
– Remove the bolts -arrows-.
– Remove inner guide piece -2-.
Installation
• For the correct tightening specifications, refer to ⇒ page 162 .
Install in reverse order of removal. Note the following:
– Tighten the screws in the sequence -1-3-.
– Install the bumper. Refer to
⇒ “2.4.1 Rear Bumper“, page 182 .
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
188 Rep. Gr.63 - Bumpers
To Next Page
Loading...
