Audi TT 207 - 1.3 Lock Carrier with Attachments

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.3 Lock Carrier with Attachments
1 - Lock washer
❑ Secures the impact
member and must not
be loosened to remove
the lock carrier.
2 - Bolt
❑ 30 Nm
3 - Side impact bar
❑ Must not be removed
from bumper bracket
with removing lock car‐
rier.
4 - Bolt
❑ 6 Nm
5 - Lock carrier
Note
❑ Removing
– Remove the front bump‐
er:
❑ Audi TT
⇒ “2.1.2 Front Bumper“,
page 165
❑ Audi TT RS
⇒ “2.2.1 Front Bumper“,
page 170
– Remove headlight. Re‐
fer to ⇒ Electrical Equip‐
ment; Rep. Gr. 94 ;
Removal and Installa‐
tion
– Disconnect the control
cable for the front lid lock from the coupling:, .
❑ Audi TT: ⇒ “2.1.6 Front Hood Lock Release Cable“, page 31
❑ Audi TT RS: ⇒ “2.2.13 Hood Lock Control Cable Mount“, page 47
– Remove bolts -2- on longitudinal member.
Note
– Remove bolts -6- on fender and bolts -4-.
– Remove lock carrier toward front.
❑ Installation: in reverse order.
6 - Bolt
❑ 23 Nm
7 - Frame
❑ Removing, refer to ⇒ page 8
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
4 Rep. Gr.50 - Body Front