Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.4 Plenum Chamber Cover
1 - Hood seal
❑ When installed correct‐
ly, seal must lie over ple‐
num chamber cover as
shown in the illustration.
2 - Plenum chamber cover
❑ Wiper arms removed.
Note
❑ Lid seal removed.
❑ Remove trim panel up‐
ward diagonally from
edge strip beginning at
window edge.
❑ Vehicles with bolts
⇒ page 6
Caution
Risk of window breaking
during installation
Do not hit the trim when
installing it.
Carefully press in trim
sideways, beginning in
edge strip.
3 - Molding
❑ For easier removal/in‐
stallation of plenum
chamber cover, spray
molding with soapy sol‐
ution.
❑ No replacement part
4 - Windshield
5 - Plenum chamber
6 - Bulkhead trim
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Removal and Installation 5
To Next Page
Loading...
