Audi TT 207 - Front Bumper - Audi TT; Upper Bumper Covers; Removal and Installation

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2 Removal and Installation
⇒ “2.1 Front Bumper - Audi TT“, page 164
⇒ “2.2 Front Bumper - Audi TT RS“, page 170
⇒ “2.3 Rear Bumper - Audi TT“, page 174
⇒ “2.4 Rear Bumper - Audi TT RS“, page 182
2.1 Front Bumper - Audi TT
⇒ “2.1.1 Upper Bumper Covers“, page 164
⇒ “2.1.2 Front Bumper“, page 165
⇒ “2.1.3 Impact Member“, page 166
⇒ “2.1.4 Inner Wheel Housing Liner“, page 167
⇒ “2.1.5 Lower Bumper Bolting Points“, page 168
⇒ “2.1.6 Noise Insulation“, page 168
⇒ “2.1.7 Bumper Guide Piece“, page 169
⇒ “2.1.8 Air Grille“, page 170
2.1.1 Upper Bumper Covers
Removing
1 - Left cover
❑ To remove, unclip up‐
ward from lock carrier
and remove sideways
from cooler grille.
2 - Radiator Grille
❑ Removal, refer to
⇒ “3.3.1 Radiator Grille“,
page 235
3 - Right cover
❑ To remove, unclip up‐
ward from lock carrier
and remove sideways
from cooler grille.
4 - Lock carrier
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
164 Rep. Gr.63 - Bumpers