Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
50 – Body Front
1 Removal and Installation
⇒ “1.1 Front Fenders“, page 2
⇒ “1.2 Engine Mount Brace“, page 3
⇒ “1.3 Lock Carrier with Attachments“, page 4
⇒ “1.4 Plenum Chamber Cover“, page 5
⇒ “1.5 Engine Mount Brace Reinforcement“, page 6
⇒ “1.6 Bumper Bracket“, page 7
⇒ “1.7 Noise Insulation Frame“, page 8
⇒ “1.8 Fender Brace“, page 8
⇒ “1.9 Fender End Plate“, page 9
1.1 Front Fenders
1 - Bolt
❑ 11 Nm
2 - Bracket
3 - Fender
❑ Removing
❑ Loosen sill panel cover
in fender area.
❑ Headlamp removed, re‐
fer to ⇒ Electrical Equip‐
ment; Rep. Gr. 94 ;
Removal and Installa‐
tion
– Remove the front bump‐
er:
❑ Audi TT:
⇒ “2.1.2 Front Bumper“,
page 165 ,
❑ Audi TT RS:
⇒ “2.2.1 Front Bumper“,
page 170
– Remove wheel housing
liner. Refer to
⇒ “3.8.1 Front Wheel
Housing Liner“,
page 255 .
– End plate, removing, re‐
fer to ⇒ page 9
– Remove bolts and re‐
move fender.
❑ Installation: in reverse
order.
4 - Brace
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2 Rep. Gr.50 - Body Front
To Next Page
Loading...
