Audi TT 207 - Door Trim Reinforcement; Outer Window Shaft Strip, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Door trim reinforcement
To remove, drill out rivet heads and drive out rivet shafts.
Outer Window Shaft Strip, Removing and Installing
1 - Door
2 - Spring nut
❑ Pressed into door
flange.
3 - Window shaft strip
❑ Door trim and door win‐
dow removed. Refer to
⇒ Body Interior; Rep.
Gr. 70 ; Removal and
Installation
– Remove A-pillar trim.
❑ Remove bolts and re‐
move window shaft
strip.
❑ When installing, align
shaft strip on B-pillar
and secure with bolts
-4-.
4 - Bolt
❑ 1.5 Nm
Inner window shaft strip, removing and installing
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
94 Rep. Gr.57 - Front Doors, Central Locking System