Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.4.3 Release Cable Coupling
Release Cable Coupling
1 - Release cable coupling
❑ Coupling is clipped into
inner part of lid.
❑ Remove retainer side‐
ways and fold coupling
up.
❑ When installing, retainer
must be slid back into
coupling.
2 - Cable
❑ Route cable ball in cou‐
pling, close lid and slide
in retainer.
3 - Retainer
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
22 Rep. Gr.55 - Hood, Lids
To Next Page
Loading...
