Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
14 - Right inner guide piece
❑ Removing and Installing, refer to ⇒ “2.4.9 Inner Guide Piece“, page 188
15 - Right holder for bumper
❑ Removing and Installing, refer to ⇒ “2.4.7 Rear Bumper Bracket“, page 187
16 - Side impact bar
❑ Observe country-specific versions.
❑ Removing and Installing, refer to ⇒ “2.4.6 Impact Member“, page 186
Tightening Torque and Sequence for Inner Guide Piece
– Tighten the bolts in a -1 through 3- sequence to 2.5 Nm.
Tightening Torque and Sequence for Guide Piece
– Tighten the screws and nuts in the following sequence:
-1 through 4-.
1 - Bolt - 2.0 Nm
2 - Bolt - 2.0 Nm
3 - Bolt - 2.5 Nm
4 - Nut - 6.5 Nm
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
162 Rep. Gr.63 - Bumpers
To Next Page
Loading...
