Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.1.4 Outer Sill Panel Strip
1 - Outer door sill molding
❑ Removing
– First unclip bottom of sill
panel strip, then pull
front of it up from door
flange and remove un‐
der door seal.
❑ Installing:
– Remove protective film
from adhesive tape.
– When installing, ensure
sill panel strip slides in
under door seal on body
flange -arrow- and is
pressed onto front of
door flange -arrow-.
2 - Door seal
❑ Outer door seal
3 - Door
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
3. Removal and Installation 229
To Next Page
Loading...
