Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.1.10 Hood Release Lever Cover
Removing
1 - Lower A-pillar trim
2 - Hood release lever cover
❑ Before removal, first dis‐
engage cable in cou‐
pling in engine compart‐
ment ⇒ page 33 .
❑ Raise operating lever
approximately 90° and
pull toward center of ve‐
hicle and out of release
lever.
3 - Hood release lever
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation 35
To Next Page
Loading...
