Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.1.3 A-Pillar Seal
Removing
1 - Guide rail
❑ To remove, drill out rivet
heads -4- and drive out
rivet shafts.
2 - Sealing molding
❑ No replacement part
3 - Sealing band
❑ Self-adhesive.
4 - Pop rivet
❑ Quantity: 5
5 - A-pillar seal
❑ Roof frame trim re‐
moved. Refer to⇒ Body
Interior; Rep. Gr. 70 ;
Removal and Installa‐
tion
❑ To remove, remove
from guide rail.
❑ For easier assembly,
coat seal with soapy sol‐
ution.
❑ When installing, engage
in guide rail as shown.
Removing Protective Tubing
– With a new windshield -1-, protective tubing -2- must be re‐
moved from molding -3- before installing plenum chamber
cover -4-.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation 203
To Next Page
Loading...
